Systems


On-Board MultiGas Leak Detection System
On-Board MultiGas Leak Detection System
Gas-Well Monitoring System
Gas-Well Monitoring System
Awair Gas Monitoring System
Awair Gas Monitoring System
Standalone
Standalone
PC-Based
PC-Based
Auto Calibration
Auto Calibration
MagneBoss Belt Controller
MagneBoss Belt Controller

Standalone Systems


Gas-Well Monitoring System
Gas-Well Monitoring System
RM420i
RM420i
PLC Express
PLC Express
Telecon
Telecon
RMCalibar
RMCalibar
SafeBoss
SafeBoss
SafeBoss FT
SafeBoss FT
SafeBoss FTL
SafeBoss FTL
productssystemsstandalone systemsrmcalibar

RMCalibar - Remote Calibration Panel


CONTACT SALES
Rem CalibarRem Calibar

Sensors are seldom sited for easy access. Methane and natural gas sensors are normally installed in the roof peaks and skylight areas, because methane is lighter than air. Propane sensors are placed low near the floor and in service pits because this gas is heavier than air. Remote calibration permits each sensor to be calibrated and adjusted without risking accidents with lifts and ladders. There is, of course, no need to stop production and move vehicles out of the way to access sensors directly. On initial installation, gas supply tubing is installed for delivering calibration gas to each sensor from a convenient floor level station. The two 4-channel Rem-Cal circuit boards in the DXcalibar or RMcalibarTM boxes permit each of eight sensor signals (4-20ma) to be finely adjusted. Test jacks are included on these Rem-Cal modules for local read out of the raw signal from each sensor as well as the calibrated signal, using a hand held milli-ammeter.

RemCal is a registered Rel-Tek trademark.



Lets Get in Touch!

Your inquiries will promptly be answered.

Phone Call Icon SVG Image

Call us

412-3736700

Letter Icon SVG Image

Email us

sales@rel-tek.com