Rel-Tek's Latest Innovations

Home >> Products >> Systems >> MagneBoss Accessory Pull Key

MagneBoss - Accessory Pull Key

Pull Key

On/OFF Pull Cord Switch (Pull Key) provides quick response shut-off of equipment. The Pull Cord Switch is designed with manual operation and control hand lever located on the side of the unit, along with an Indicator Flag. The Flag is in the “Upright” position when the switch is in the ON mode, and the Flag is “Down” in the OFF mode. Upon proper installation the Pull Cord Switch’s Micro-Switch contacts provide shut-down of equipment when the pull cord is used as an emergency shut off. Mount near conveyor belt. Wire to the normally open contacts of switch and the pre-determined digital input of the controller (if applicable).

Specification Sheet

Physical-
SizeEnclosure: 10”L x 7”W x 5”H
Overall: 22”L x 7”W x 5”H
(8”H when flag is activated)
Weight 7 pounds (3.2 kg)
ConstructionFiberglass enclosure
Hinged lid w/screws closure
Hardware Coated Steel
Terminals (2) No polarity
Cable access (1) 1” hole, with cord grip
Electrical-
Contact voltage 125, 250, 480 VAC125 VDC250 VDC
Contact Current Maximum 1.5 Amp AC½ Amp DC¼ Amp DC
Environmental effects-
Temperature 0-46C (32-110F)
Humidity5-95% non-condensing
Altitude/pressureNone
Warranty 1-yearRev. 180615
B and B Products
Box 303
Seward, PA 15854
Ph: 814-446-5663
Distributed by