Rel-Tek's Latest Innovations

Home >> Products >> Systems >> MagneBoss Accessory Belt Alignment Switch

MagneBoss - Belt Alignment Switch

Belt Alignment Switch

Belt Alignment Switch is designed to trip when the control arm’s travel exceeds the pre-set points. Upon proper installation, the alignment switch roller is positioned so that if the conveyor belt does not track properly the belt will make contact with the roller forcing it to trip the contacts. Mount roller near belt, do not allow belt to touch roller. Wire to the normally open contacts ofswitch and the pre-determined digital input of the controller (if applicable).







Specification Sheet

Physical-
SizeEnclosure: 9”W x 4”H x 4”D
Overall: 9”W x 10”H x 4”D
Weight 9 pounds (4.1 kg)
ConstructionPainted steel enclosure
Hinged lid w/latch
Hardware Coated Steel
Terminals (2) No polarity
Cable access (1) 1” hole, with cord grip
Electrical-
Contact voltage 600VAC max.
Contact Current Maximum 4 Amp
ActivationMercury Switch
Environmental effects-
Temperature 0-46C (32-110F)
Humidity5-95% non-condensing
Altitude/pressureNone
Warranty 1-yearRev. 180615
B and B Products
Box 303
Seward, PA 15854
Ph: 814-446-5663
Distributed by